PDA

View Full Version : IMPORTANT; Transponder locations



NEETS-1
05-30-2006, 11:31 PM
I noticed in a few of the TRUX the unit were located near the rear body panel up on the hump. Some were 2 to 3 inches up out of the hole. The holes were also too small. There was a problem picking up signals in these certain TRUX. Please cut a "3x3" hole in the passenger floor as per the rules...and mount the unit so the bottom of it is flush with the hole. The flap must be pulled up towards the doors (either driver or passenger door). The signal must hit the track. Just one note...make sure it is not above a hot exhaust pipe.
The units were fine when mounted properly....please fix this before the next event or I will not guarantee your finishing position with a hand scored truck.
Just FYI....the same units were used in the 4cyls and worked properly. It is the mounting. It was the only division we had a problem with.