At the last race at grandview Joe was measuring cars to see if the cutout was in a good spot, any info on where to put the cutout ?? I am building a new car. :help::D
Printable View
At the last race at grandview Joe was measuring cars to see if the cutout was in a good spot, any info on where to put the cutout ?? I am building a new car. :help::D
yes in your car! :lol: just kidding. i have mine on passenger floor. make sure you can reach it easily. lower is better.
Yea inside car thanks !!:wave: Joe was measuring the wheel base for some reason and not sure why, In my last car it was about even with the drivers seat just wondering if that's the right place. :help:
Just look in the new rule book, in Chapter five section 502. It's all right there.
Poppop
Thanks for all the help
its all about location.... passenger side floor board, approx 3' from center of front hub..
with an unobstructed view of the track, and like Pop Pop said with in your reach.
Maddawg
With the front/back of the transponder mounted parallel to the doors. This gives the transponder a longer time to send a signal to the loop in the track. phil
t
r
a
n
s
p d
o o
n o
d r
e
r
Wow ur smart old guy...........:lol:
Neither old nor smart. Just an Enduro supporter. phil